ljfaraci
Sep 09, 2004, 07:03 PM
I'm asking $125 for this pump - it has never been installed in a boat.
Perhaps the EASIEST drive system to install in a fast boat. It can be installed into deep-V’s, and flat bottom boats with by just making a simple cutout and adding some reinforcement in the boat hull bottom. Turn rudders and reverse bucket are included. Enormous acceleration, extreme maneuverability (it can turn on a dime). For use with Nitro engines from .21 to .90 or strong electric motors. Design of the suction channel allows running at a pronounced tilt for in rough water. Strong, glass filled nylon construction. Shaft is 7mm but the end to be coupled to a motor is 5mm. Impeller diameter is 40mm (1.58"), Size is 11-1/2" long x 2-1/2" wide, weight 10.5 oz. Jet Drive:
Perhaps the EASIEST drive system to install in a fast boat. It can be installed into deep-V’s, and flat bottom boats with by just making a simple cutout and adding some reinforcement in the boat hull bottom. Turn rudders and reverse bucket are included. Enormous acceleration, extreme maneuverability (it can turn on a dime). For use with Nitro engines from .21 to .90 or strong electric motors. Design of the suction channel allows running at a pronounced tilt for in rough water. Strong, glass filled nylon construction. Shaft is 7mm but the end to be coupled to a motor is 5mm. Impeller diameter is 40mm (1.58"), Size is 11-1/2" long x 2-1/2" wide, weight 10.5 oz. Jet Drive: