Converting JR to Futaba

[Not]

I have a JR compatible GWS ICS100 ESC and would like to use it with my Futaba compatible GWS RX. Anyone know how to rewire?

[Majortomski]

Think the only thing that is significantly different between JR and Futaba is the polarity shift of the transmitted signal, which is receiver unique. Otherwise all other components are interchangeable. I use JR servos all the time in my Futaba receivers.


HTH

Tom

[Fantam]

It will work fine without re-wiring.

[Not]

I have a GWS r4p (Futaba) 2 GWS pico servos (Futaba) and a GWS ICS100 ESC (JR) with all of this connected, it does nothing. I have tested everything with my JR610 RX and all components work. Maybe the RX(Fut) doesn't like the ESC(JR)?

[Miami Mike]

JR radios have the throttle on channel 1, Futaba radios have it on channel 3. You'll also need to reverse the servo setting.

[slipstick]

What TX ? If you swapped the RX didn't you also use a different TX ?

The ESC will work with either RX.

Steve

[Not]

JR Quatro TX. Two different RXs (JR & GWS)

[Fantam]

The problem is with your trasmitter/receiver combination, not the other parts. You need to use a Futaba shift receiver with a Futaba transmitter. And JR shift with JR transmitter. You are trying to use a Futaba shift receiver with a JR transmitter. That wont work. You will need to get a JR shift receiver

[slipstick]

As Fantam says you can't use a JR Tx with a Rx that is only compatible with Futaba Txs. It's nothing to do with the ESC.

Steve

[Not]

Thanks