Reflex XTR helicopter model setup

[bret4]

I find that all the helicopter models do not fly in Reflex XTR. I have adjusted the model settings for the Corona and it flys just ok. Am I missing something? My real Corona flys much better than the one on Reflex. If I didn't change the settings for it, I wouldn't be able to keep it in the air long at all. The real Corona I can fly a full battery pack in hover no problem. So far I have to say that Reflex XTR sucks. Maybe I am missing something in the settings. Tried everything I can think of for over 10 hours. Just ok. FMS was better at this point. Graphics look nice and that is it. Help!

[Charlie06]

What do you mean they wont fly? Do you mean they wont come off the ground? Make sure you have your throttle trim up about 3/4. Need a little more info on what you mean so we can help. My Reflex works great.



My Gallery (http://www.villagephotos.com/pubbrowse.asp?selected=121351&foldername=Photos)

[Wright Flyer]

Bret,

I find the Corona in XTR is VERY realistic. There must be something wrong with your TX setup though I can't think what.

Are you trying to use the same model memory in your Tx for the sim as you do for the actual helicopter? For XTR I use a spare model memory in my Tx and have everything set to defaults (so all EPAs 100% etc)

Cliff

[Mike Parsons]

I do find that my controls have to be reversed to fly Helis in XTR vs what they are set at for the Planes. I found that to be odd. Other than that, I havent had any trouble.

-m