John Doe
Jun 21, 2004, 02:55 AM
Well, the bilge pump does operate when using the wet finger short out across
the blades of the fuse.
However, on the shake down run, I'm still having trouble getting both
engines to fire together when the right stick is used. This stick operates
the rudders too. Next time out I will get my Son to operate the boat with
the deck open, to test the Speed control cooling system while I hold the
stern. I cant figure out if its heat activated , or run by the
transmitter.Actually , I could do this in the tub!
Today, out in the garage, I ran the boat on the cradle. When done farting
around; I felt the cooling pump motor and it was warm(not hot). Sure wish I
had one of you " Senior " guys to look at this transmitter. I may have to
take it and the boat into my local R/C Dude.
All for the moment,,Scott
the blades of the fuse.
However, on the shake down run, I'm still having trouble getting both
engines to fire together when the right stick is used. This stick operates
the rudders too. Next time out I will get my Son to operate the boat with
the deck open, to test the Speed control cooling system while I hold the
stern. I cant figure out if its heat activated , or run by the
transmitter.Actually , I could do this in the tub!
Today, out in the garage, I ran the boat on the cradle. When done farting
around; I felt the cooling pump motor and it was warm(not hot). Sure wish I
had one of you " Senior " guys to look at this transmitter. I may have to
take it and the boat into my local R/C Dude.
All for the moment,,Scott