bruce
Jun 06, 2004, 10:00 PM
Hi
I got a new t-maxx last week. During the break in period the brakes
began to fail even though I was driving easy. Examination of the disc
showed that it was rounded in the centre. I got a new disc and pulled
the transmission to fit it.
I then discovered that the yoke pin which secures the hex adapter was
protuding about 2mm from the non-treaded side. Is that right also any
ideas on why the original disc rounded.
Thanks a lot
Bruce
I got a new t-maxx last week. During the break in period the brakes
began to fail even though I was driving easy. Examination of the disc
showed that it was rounded in the centre. I got a new disc and pulled
the transmission to fit it.
I then discovered that the yoke pin which secures the hex adapter was
protuding about 2mm from the non-treaded side. Is that right also any
ideas on why the original disc rounded.
Thanks a lot
Bruce