Threading the sail servo

[dborsoi]

I am new to RC sailing and I recently purchased an M class sailboat. I was able to use it once before my 2yr old son played with the sails servo and removed the sail sheet line. The jib and main sail are both on one continuous line and I can't figure out how to put it back. Does someone have a diagram or an explanation on how to thread the servo?

Frustrated...

Dennis
:confused:

[DrElectron]

Dennis...

To help we will need a bit more information... Boat make and model would be a big help... Picture of servo/sheet area could help as well... Take care...

Bruce... :cool:

[sailvt]

...check for either an attached ring or a small tied loop somewhere on the continuous loop...thats where you want to attach both your main and jib sheets.

If you don't see this try going to the AMYA site and looking up their M-class link. Someone in that class should be able to tell you where and how to attach your sheet lines. You may find someone or a club local to you through them. The site is www.amya.org

Ken