Please help! Transmitter is back to front

[dragonfly]

Hi. I just installed FSM on my computer and linked up my Zhen Hau PCM
4CH transmitter. The simulator programme recognizes the transmitter
but the throttle control on the simulator is on the right instead of
the left where it ought to be, and is, when I fly my electric
Dragonfly helicopter. Any idea how I can make the transmitter work
correctly on the sim would be greatly appreciated.

[S-Man]

Look in the help files to find out how you can change the configuration
of the program so your controller is Mode 2 (Not mode 1 as you describe)

..S.


dragonfly wrote:

> Hi. I just installed FSM on my computer and linked up my Zhen Hau PCM
> 4CH transmitter. The simulator programme recognizes the transmitter
> but the throttle control on the simulator is on the right instead of
> the left where it ought to be, and is, when I fly my electric
> Dragonfly helicopter. Any idea how I can make the transmitter work
> correctly on the sim would be greatly appreciated.

[The Observer]

Turn the transmitter upside down?

dragonfly wrote:
> Hi. I just installed FSM on my computer and linked up my Zhen Hau PCM
> 4CH transmitter. The simulator programme recognizes the transmitter
> but the throttle control on the simulator is on the right instead of
> the left where it ought to be, and is, when I fly my electric
> Dragonfly helicopter. Any idea how I can make the transmitter work
> correctly on the sim would be greatly appreciated.

[Oliver]

Hi

Go through the following menu:
Controls > Analog Control > Mapping/Calibration

then rearrange the channel numbers in the last four
boxes which are labeled Tail, Nick, Roll and Pitch.
Mine is set up as 4, 1, 2, 3 but I think that depends
on the transmitter or joystick type interface your using.
It should be pritty easy to swap the numbers around
to get what you want.

You will probably need to go through the calibration
in that dialog as well.

Oliver