MICRO RS4 Questions................

[JIMJAM]

Just bought a totally modded out, hopped up RS4 MICRO. Hardcore Racing titanium chasis, eveything else is aluminum or CF,Big block motor, 2 cell 1200 Etecs.FFAASSTT.... Anyways, WHERE can I find a tool to take on and off the 2mm lock nuts on the wheels???? I own a few 2 and 3 ways but they are too big and I cannot find anything that small. The alloy rims are $100 so needle nose pliars are out. ALSO- Are there TALLER tires so I can get this incredibly LOW to the ground car up a little? Anything less than pool table smooth is a rough ride with it bottoming out. I understand the lower the better but I cannot even run it on the street as is. THANKS.....

[hotrod81]

GHracing makes a nice 4 way that fits. the stock rs4 comes with a
plastic one that works. if you cant find one let me know i have a couple extra. someone does make taller tires and wheels but i cant rember who. i'll have to look it up.

[JIMJAM]

Hey Aiken! Yeah the car is just too low for anything other than a prepared track. If you can track down some taller tires I would appreciate it.

[JIMJAM]

HOTROD81- Found who made it but now need to find it in stock..

[hotrod81]

cant help you on who stocks them but well keep tryin.:( :)

[JIMJAM]

Just ordered one and bought some soft foam donuts. Still never saw taller tires. Handles good on grainy asphalt at low to med speeds but faster and the car chatters. Wide open with the big block and its almost uncontrollable.

[hotrod81]

the hardcore chassis tends to hop under high traction conditions.
too soft i think. ours is fast on 7.2 nimh so theE-tecs should be way fast. We'll have to get together and race sometime.