NickT
Aug 12, 2003, 04:20 AM
Hi All
First off this is a great heli but, in my experience, its achillies heel is the tail and the vibrations it causes effecting the gyro gain I can set.
I have placed a third tail shaft guide in it, put the robbe fix pack on, balanced the tail blades and moved the gyro from the oscillation prone rear rc mounting plate onto the side of the tail servo with double sided tape. The result is a big improvement but still no where near good enough when i try to go to idle up 1 or 2. In other words fine at lower rpms in normal hover now (never was) but thats it.
Does any one have a solution - I am sure that I cannot be the only one with this issue!
Is the decased CSM200HLG prone to such vibrations more than most is another thought i had.
Thanks in advance
Nick
First off this is a great heli but, in my experience, its achillies heel is the tail and the vibrations it causes effecting the gyro gain I can set.
I have placed a third tail shaft guide in it, put the robbe fix pack on, balanced the tail blades and moved the gyro from the oscillation prone rear rc mounting plate onto the side of the tail servo with double sided tape. The result is a big improvement but still no where near good enough when i try to go to idle up 1 or 2. In other words fine at lower rpms in normal hover now (never was) but thats it.
Does any one have a solution - I am sure that I cannot be the only one with this issue!
Is the decased CSM200HLG prone to such vibrations more than most is another thought i had.
Thanks in advance
Nick