PDA

View Full Version : RS-232 Beta Speed Controls

Speed-3
Jul 31, 2003, 04:36 AM
We are going to be Testing our new line of Rs 232 Programing
Speed controls On Aug 21 beta testing of our Win Xp Me 98 based software and controls are needed.The Units use a Rs 232 to 3 wire Radio connector. some of the features are: Temp of MosFets,End points, Brake and Brake level,Radio set up,Use count,Battery cut off even though they sence and write it on start up.and many others.I have added a very Rough picture of a Alfa Ver of our software.As we have much to do still we wanted to get some ideas on what every one would like to see in our software.

We can take 5 persons to get this set up You'll get software for your Pc and a control to test.Please email me direct.

Shipping of software and controls are not untill Aug 21
Also An NDA is part of this beta test and is a MUST !

No MFGS. No DEALERS Please.

All the forms needed should be posted on our web site soon.

As of 6-31-03 our site is not ready yet.

www.speed-cubed.com


Got ideas? Email me!

Ken Anderson
Speed-Cubed
Speedcontrol@comcast.net
hoppy
Sep 27, 2003, 09:33 PM
Is this the site where the info will be posted?
http://www.speed-cubed.com/
Thanks
hoppy
Speed-3
Sep 27, 2003, 09:38 PM
Yes.we just finished our new controls this last week should have all brushed and brushless up very soon.



Ken
DNA
Oct 27, 2003, 04:04 PM
Any more info on these speed controllers yet?

Size, weight, specs, features, prices, etc.
Speed-3
Oct 27, 2003, 04:12 PM
We have run short of funding.
I hope to get going again here real soon.
The market is very hard to get into but were doing our best.
Our brusheless unit was almost 100% done but funds are to tight to finish right now.

Ken
zagisrule!
Oct 31, 2003, 06:31 PM
Good luck Ken!

I hope you make it man...
DNA
Dec 06, 2003, 03:58 PM
Just thought I'd check again. Any news yet?
Speed-3
Dec 06, 2003, 05:05 PM
We are trying to get going again.Should be some time soon.
In short we need to pay down some bills first.
we incountered some rather large debt in the design phase
and in our over sampling of our brushed unit's but.
You can Pm me with your email and ill send some more information id like to not post at this time.

Here is a look inside the site if anyone would like tohave a look.

http://www.speed-cubed.com/cgi-bin/index.pl







Ken