Flash 5X won't change model modes? [Archive]

View Full Version : Flash 5X won't change model modes?

Mike C

Jul 03, 2003, 12:55 AM

I was trying to change in glid acro to use dual aileron servos and after following instuctions on page 11 it will not change modes when pressing the cut/save key. Acro blinks when it is turned on so I am pushing both keys at the same time. Any suggestions?
Any other advice regarding dual servos in ailerons would be appreciated as well. Thanks.

MikeMayberry

Jul 03, 2003, 03:45 PM

It's tough to explain things like this over the forum, especially if you followed the directions because that is what I would tell you too. The best thing to do is call our customer service and we can walk you though it. (858)748-6948

You will need to use GLID/ACRO for dual ailerons unless you use a y-harness.

Mike