erashby
Jun 23, 2003, 02:40 AM
Patrick,
I received the Phoenix 10, and it works better with the PJS 300 outrunner motor and three lithium cells than my Phoenix 25 did with the old firmware and three lithium cells. The Phoenix 25 is on its way back to you to be upgraded to the new firmware.
I am still having a problem with the Phoenix 10 and the PJS 300 on three lithium cells. The engineer who designed the PJS recommends that the timing be advanced to 30 degrees, but it will run fine with a less advanced timing. When I advance the timing to 15degrees -option 1 when programing- the motor slows down after about half throttle. It does this with either 2 or 3 lithium cells. It does this on any timing advancement (option 1 or 2, but not on 3 the default).
Any ideas what is going wrong?
I received the Phoenix 10, and it works better with the PJS 300 outrunner motor and three lithium cells than my Phoenix 25 did with the old firmware and three lithium cells. The Phoenix 25 is on its way back to you to be upgraded to the new firmware.
I am still having a problem with the Phoenix 10 and the PJS 300 on three lithium cells. The engineer who designed the PJS recommends that the timing be advanced to 30 degrees, but it will run fine with a less advanced timing. When I advance the timing to 15degrees -option 1 when programing- the motor slows down after about half throttle. It does this with either 2 or 3 lithium cells. It does this on any timing advancement (option 1 or 2, but not on 3 the default).
Any ideas what is going wrong?