OSD Pro and Data Recorder

[camship]

Bill,

Has the AHI function been ported to the Data recorder yet? I didn't see any mention in a scan of the software version info:(

Am I making an incorrect assumption that the original Co-Pilot (FS8) and the Co Pilot II use the same pitch/roll sensor?

Thanks much,

Camship

[billpa]

Hi Camship,

We are doing a little add-on board to support the FMA sensors with the recorders and eLoggers. Yes, the FS8 and CP2 sensors are completely different (analog vs digital).

Regards,

Bill, for Eagle Tree

[camship]

Thank you for the response.

I am using the original FS-8 and it uses the same analog sensors as the CPD-4 so I should be OK.

I don't mind scratching up equipment. If the Recorder firmware/software supports it I would happily cobble-up the interconnect.

Is there any reference material for using the OSDPro+CPD4 sensors+Recorder? I would appreciate more information if it is available.

Thanks again,


Camship

[arkcom]

Here you go.

http://www.eagletreesystems.com/support/manuals/FMA-OSD-Pro.pdf

[camship]

Here you go.

http://www.eagletreesystems.com/support/manuals/FMA-OSD-Pro.pdf

Thanks but did you see the part where it says;

e) connect the newly created 2 wire plug to the center pins of the “temp 2” and “temp 3”
eLogger V3 inputs, as shown in Figure 2. (note: this is not yet supported for Recorder
users, but will be soon). Note that the red wire goes to the center pin of “temp 2”, and
the black wire to the center pin of “temp 3.”

That is why Bill posted about the add-on board. Looks like I will have to wait:(

I do have a eLogger V3 but it is dedicated elsewhere on a 20Ah, 16 cell A123 pack.

Camship