Shuttle - getting after-run oil into engine

[David]

Hi,
I have a Shuttle fitted with an OS32, in-which the carb is completely
shrouded by the air cooling ducts, which makes it impossible to get any
after-run oil into the engine - does anyone have any ideas or experience of
doing this please?

David

[David]

Hi,
Thnxs, I'll give that a try tomorrow
David

"Courseyauto" <courseyauto@aol.com> wrote in message
news:20030418152242.19041.00000141@mb-m05.aol.com...
>
> Hi,
> I have a Shuttle fitted with an OS32, in-which the carb is completely
> shrouded by the air cooling ducts, which makes it impossible to get any
> after-run oil into the engine - does anyone have any ideas or experience
of
> doing this please?
>
> David>>
>
> I re3move the glow plug and put it in there, tilt the engine away from
the ex
> port and make the piston is all the way down by pushing dowm on it with
your
> oiler.

[Brian Standing]

Spray WD40 direct into the carb inlet via the little tube they supply and a
piece of fuel tube, it works just as well.


"David" <david@noname.bt.com> wrote in message
news:b7pio2$9k9$1@sparta.btinternet.com...
> Hi,
> I have a Shuttle fitted with an OS32, in-which the carb is completely
> shrouded by the air cooling ducts, which makes it impossible to get any
> after-run oil into the engine - does anyone have any ideas or experience
of
> doing this please?
>
> David
>
>