Jetibox issue.

[Panacopter]

I just acquire a new Jetispin 55 ESC and a Jetibox. However the box doesn't recognize the controller just as the manual says. But only appears "servo test". Nothing else is shown in the screen.
By the way I followed the instructions just as the manual says:
1. Plug the ESC cable in the gray slot
2. Plug the flightpack to the ESC
3. Turn the switch on
4. "just wait" appears in the screen and next the phrase "servo impulse"

It seems it does not recognize the controller.

Any suggestions???

[Jay Burkart]

I recently had the same problem with a Jetibox and it gave the same indication.
I asked JETI and they told me it most likely was bad.
So I had to buy another.
Was your Jetibox new from Hobby Lobby?
Jay

[Panacopter]

Yes, I received just a few days ago

[Jay Burkart]

Go to the Hobby Lobby site and put in a support request then they can exchange it for you.
Regards,
Jay