XLR5 help, "can't find stab airfoil"

[Mtntop]

I'm new to this program and have been reading the articles on how to get started.
I've imported my foils and did the batch analysis for each the wing and stab. I then designed the wing with its airfoil and named it. Then I defined a plane by importing the wing and hitting the button for "define" stab...designed stab with airfoil...but when I go to do the Type 2 analysis and put in my steps and such it says "Could not find elevators foil aborting calculation.

I have gone through this procedure from a clean state 3 times now and am getting a bit..... well you know. :mad:

Thanks for the help in advance.
Dave

[Mtntop]

HA! Amazing what happens if you just step back for 10 minutes or so! Yep it was staring right back at me in all it's glory...I failed to inser a airfoil in the very root of the stab! HAHAHA.
Let this be a lesson.