Re: Solder Help

[pcmww1]

Ensure you apply the Flux on the Flex Drive and Inside the Ferrell.

You also must use a Propane Torch (Sears) to produce the necessary
heat. This is critical.

I just did this for the first time two weeks ago when finishing my
scratch built boat. It worked perfectly.


--
pcmww1
------------------------------------------------------------------------
pcmww1's Profile: http://www.modelpowerboat.com/forum/member.php?userid=7753
View this thread: http://www.modelpowerboat.com/forum/showthread.php?t=1162
Free RC Model Boat Plans: http:\/\/www.modelpowerboat.com\/forum\/downloads.htm

[Randy]

There is another way... see
http://www.offshoreelectrics.com/info-pages/assemble-shaft.php
I used this method on a 12 cell rigger putting out 750 watts and have had no
problems to date.

Randy

"pcmww1" <pcmww1.3pz720@no-mx.forums.modelpowerboat.com> wrote in message
news:pcmww1.3pz720@no-mx.forums.modelpowerboat.com...
>
> Ensure you apply the Flux on the Flex Drive and Inside the Ferrell.
>
> You also must use a Propane Torch (Sears) to produce the necessary
> heat. This is critical.
>
> I just did this for the first time two weeks ago when finishing my
> scratch built boat. It worked perfectly.
>
>
> --
> pcmww1
> ------------------------------------------------------------------------
> pcmww1's Profile:
> http://www.modelpowerboat.com/forum/member.php?userid=7753
> View this thread:
> http://www.modelpowerboat.com/forum/showthread.php?t=1162
> Free RC Model Boat Plans:
> http:\/\/www.modelpowerboat.com\/forum\/downloads.htm
>