Doubledog
Mar 29, 2009, 11:37 AM
Hi Gang, recently got the kick to mess around with the milling machine and whipped up this display stand. Its not perfect by any means since I'm still learning and its a manual. However, I have done a few for my office where I have an RCM outdrive & 3.5 outboard for display.
Measures- roughly:
6" tall
4" long
3.5" wide
Solid aluminum stock
As you can tell, it was fun playing around but the cuts are not perfect but close. There were a few things I could've done here & there to really trick it out and for display purposes, it will help your engine get that little extra attention.
Price: Lets try $25 shipped to a US address via US priority mail & tracking number. Paypal or wait for a postal money order.
ENGINE NOT INCLUDED.
Will consider trade for various electro airplane supplies.
Best regards,
Jamie
Email or PM through this site for more pictures.
Measures- roughly:
6" tall
4" long
3.5" wide
Solid aluminum stock
As you can tell, it was fun playing around but the cuts are not perfect but close. There were a few things I could've done here & there to really trick it out and for display purposes, it will help your engine get that little extra attention.
Price: Lets try $25 shipped to a US address via US priority mail & tracking number. Paypal or wait for a postal money order.
ENGINE NOT INCLUDED.
Will consider trade for various electro airplane supplies.
Best regards,
Jamie
Email or PM through this site for more pictures.