Prather Hydro parts

[USMC & Viking]

Prather Hydro parts New

I have 2 nip "Dzus fastners" for cowl or hatch
2 nip "Drive Dogs" fits 3/16 shaft
2 nip "Thrust Bearings" fits 3/16 shaft
2 nip "Water Outlets"
1 nip "Needle Bearing"

$30.00 shipped, cash, postal M.O., dont like paypal but can do.
lower 48 only

Thanks.
USMC & Viking...! & Little Jack...! :)

PM or Email, vikingusmc@hotmail.com

[RadioAv8tor]

Hi, I'm not wanting to hijack your thread, Was wondering if you have any other Prather stuff?-Looking for Lap Cat II Tunnel? ~Mike

[Mel279]

hi

how much for just the 2 nip "Thrust Bearings" fits 3/16 shaft?

[USMC & Viking]

Hi, I'm not wanting to hijack your thread, Was wondering if you have any other Prather stuff?-Looking for Lap Cat II Tunnel? ~Mike
================================================== =======
no Lap Cat, can check a couple sites.

as for Prather parts,
props 215 & 220 nip

2 different type prop balancer made by Prather.

K&B 3.5 outboard motor mount( I can give link for these)

Sheldon's Hobbys, San Jose,Ca. has some "Prather" parts
Graves Hobby's.Fl use to has Lap Cats & Dumas boats

[USMC & Viking]

hi

how much for just the 2 nip "Thrust Bearings" fits 3/16 shaft?
================================================== =======

$10.00 , you pay shipping.

Thanks!
USMC & Viking...! & Little Jack...! :)
================================================== ========

All parts have been SOLD on a diff. site.

Thank you, Mr. Jones!