MikeBiv
Mar 24, 2009, 10:58 AM
I was thinking if trying to make a FrakenServo, trying to improve over a Futaba 3154 and Lower the Weight if Possible. Want to try to make Dymond 4.7 Digital too. IF possible turn my 3110's digital etc.
Ideally Id make a Digital Programable Brushless carbonite gear servo weighin around 6 grams. The Better the servo happier I am. Would like to make the shaft of the D47 fit 3d Arms.
Who Might sell the Electric Boards and Motors ETC?
All i can find is Gear and Case Sets.
Any DIY 4/8gram servos of excellent quality?
Ideally Id make a Digital Programable Brushless carbonite gear servo weighin around 6 grams. The Better the servo happier I am. Would like to make the shaft of the D47 fit 3d Arms.
Who Might sell the Electric Boards and Motors ETC?
All i can find is Gear and Case Sets.
Any DIY 4/8gram servos of excellent quality?