- single to twin gearbox
- which engine?
- What exactly is a 'stepped' hull?
- About the 'three degrees rule' & surface drives
- Hovercraft
- Suitable Boat For Retrieving Planes?
- Wire Drives...
- Water Turbine
- Gell Cells
- The RCGroups Fast-Electric Races...
- Speaking of Large Hulls
- baitboat problems
- postmaster@traxxas.com
- Need documentation for Picco P-45
- newbe on board
- Electric Outboards?
- Has anyone ever figured out...
- Marine Expo Seattle, Washington
- what kind of props for hovercraft?
- Mounting a rudder...
- esc which do you recommend
- Where to get Omega 15% fuel from
- Another newbie commin up!
- Try again over here
- For Sale Futaba Radio
- Recommended prop RPM
- The perfect motor?
- How can I get 'real boat' quality paint on...
- Questions on Props
- looking for an offshore plan
- what do you use for sealing?
- rudder ?
- Large Tugs
- ESC Response at low throttle.
- Ballast Tank Pumps
- First Time Fiber-glassing
- Offset rudders or not offset rudders...
- About tubes going into or out of rudders...
- Hughey Gear
- R/C equipment for micro sized boat
- Electronic Pump Switch
- dumas swamp boat
- K&B outboard need help!
- Robbe Bow thruster
- Zig Zag racers
- Stability issue
- model slipway tug
- New guy with a couple of questions...
- Basic Electronic Questions
- newbie needs some info
- Queen Mary 2 1:400 scale R/C conversion
- Help identify Kyosho boat?
- I need some input about this boat
- speed control
- Container ship
- Winter Project
- New guy here, just looking for a place to start.....
- 2005 Great Lakes Scale Model Boat Show & Regatta
- Hop Up A Wave Shark
- Bait Boats
- Flying Catamaran video! hilarious
- need help with tug setup
- Help with motor selection???
- Krazy Hydropane help?
- are there any stainless headders
- Room For Workimg
- connectors
- A twist on combat...
- Need simple safety circuit for G-23 ignition
- Q.?radio101speed controul
- DC SABRE Vintage Diesel - Pls advise
- milling planks with basic sawtable
- prather deep vee oputboard 31
- Discovery Channel MINI HOVERCRAFT
- new to this