- Newbie with electrical problems
- is this a good deal?
- Throttle connection
- 40. Flight time.
- Now?
- Help
- Great Planes GeeBee Profile Help
- good 1st 4 channel trainer? any suggestion?
- Engine question
- Glow plug question
- engine carb question
- Magnum 61 first time setup
- 1/6th Sopwith Triplane
- laterally balance?
- Seagull Harmon rocket re-attempt to fly
- Help Please.
- irvine engine (Irvine tutor 40)
- How does your club train new members?
- Yet another Electric Flyer going over to Fuel.
- Airborne 40/60 Trainer
- 30 minute epoxy
- looking to move to 4ch high or shoulder wing?
- How do I power up my Spectrum RX
- Question about Setting the CG for Nitro Planes
- trainer
- Rx combatability
- rx battery
- highband lowband
- rx battery. Remaining volts and flight time??
- hobbico nexstar- good or bad
- Cowl cut to much?
- 40 rtf alpha
- Could someone show me an arf plane that would work with this motor?
- Receiver
- Electronics For Seagull .90 Yak 54
- I want to start a flying club near Rockville, IN
- Telemaster 40
- New to RC
- Difference between these two ASP Engines
- Fueling setup
- piper cub kit
- Senior telmaster strut question
- Cleaning
- What next
- Flying wing help
- evolution .46 nx engine ??help??
- Will it matter
- OS 40 FP Parts - Source or Conversion to newer carb?
- My first flaps plane
- Kits
- large prop help...
- Noobie unknown P51 rebuild!
- Piper Cub
- Muffler gasket leaking
- glow plugs???
- Broken wheel bracket,,how do i gain access
- Going solo on Hobbico Avistar
- Kit suppliers in uk
- Piper Cub
- Guidelines for prop selection
- Buying a radio
- glow engine firewall
- What radio should I buy?
- New to Flying
- new to flying irvine engine wont start
- Nitro fuel question and help?
- TX with Glow controlled ignition
- Engine cleaning
- OS FP40 Easy Question (...will take u 2 mins)
- Prop Size question
- can i break in new engine with the larger prop for when it "ran in"
- Question on a hatch door with monokote
- Boomerang Prop clearance, quick question.
- Aileron Control Horn - Pilot Drilling?
- Need Engine Size Help