- 2 Castle Creations
- 1.22V / cell Nimh, very small 11A load on a big CC125, but still shutting down...
- Berg Newsletter Contest Results
- GWS crystals in the new Bergs?
- New Berg 4 channel RX...beta testing results?
- RPM jump at max. throttle
- CC Phoenix 25 Heli Programming SETUP HELP
- Mamba questions?
- Wow, check this out!!!
- CastleLink v2.12
- CC60 cutting out issues?
- Just wanted to drop a thank you bomb to cc great service
- Phx link won't link
- What is the juice of choice for the Mamba?
- Did Bernie Wolfard get a promotion yet?
- Phoenix History
- T-Bird18 Not Delivering the Juice
- Phoenix 10 switching "shift"
- Difference between old and new CC25?
- Thunderbird 18 Stuck in Program Mode!
- Base loaded antenna on the Micro stamp?
- Phoenix 25 Picture: Old vs New
- H.V. 85 questions
- My legs are hurting, hurry up Castle!
- Mamba set-up
- New vs old HV ESC’s
- Nice new website!
- Phoenix 10 vs Thunderbird 9
- F3A proportional brake on HV controllers
- CC35: How can I tell if it has 3A BEC
- Two brushless-sensorless motors on one ESC
- Use Schottky diode ???
- .net framework killing my laptop
- CC25 + AC DIY VL motor
- Can't figure out programming for the Phoenix10
- New CC 35 shuts of early
- Ph25 ?
- CC45HV & Castle Link 2.12
- CC10 BL ESC used in tail motor gets HOT (BCP)
- CC80 Thottle not linear (setting?)
- Need help with Futaba R203HF receiver and Mamba-25
- How do you tell if your Thunderbird 9 is a new one?
- Cc P35 Sick?
- PHX-80 cuts off/over heat early
- PHX-60 Question
- Phoenix 25 melts glue!
- Pixie-7 upgradeable to 7P ???
- New Crystals/old Rec.?
- can't get my CC25 to work with himax ha2015
- Thunderbird 18 wire problem! Try to fix? Or send back?
- CC45 needs repair!
- CC 35 just blinks?
- Phoenix 35 dead?
- What makes cdrom motors different ?
- Lipo cutoff?
- Programming Phoenix 10
- CC80 Questions
- Really Really Long Antenna?
- CC-45 on 4S?
- BEC Failure?
- maximum recommended wire length
- New Bergs, Any Short antenna testing???
- Support from CC ?
- CC 35 on fire !
- Bug in Phoenix 35 and 1.22 software with cutoff?
- Cant get Phoenix 35 in program mode
- cc25 led help
- CC25 French manual
- 7 channel version status?
- HV-125 - do they work?
- Generic 25 Software version
- Pixie 20P 3S Lipo Servo Count Limit
- berg warranty were??
- Phoenix 35/45 at 6S and "low" current?
- Castle 4 weeks? ya right!!