- CC25 Red light @ 3/4 throttle?
- Phoenix 25 BEC Question
- Motor Cutout Problems With Phoenix 25
- Newby Pixie 20P Question
- CC pixie 20 p programable
- Uh oh! Phx Link software hangs during update
- Need help finding a CC web page.
- help a newbee to BLs
- 3 brushless controllers
- Motor Cutout with CC35
- ETA of new Castle Creations / Berg-4 receivers?
- cc25 shrink wrap fell apart
- Did I Get A Bad Phoenix-25?
- Setting TX epas on high governor mode?
- What rpm-count for a two-pole motor before high-gov is to be selected over low-gov?
- PH25 1.11 Firmware update issues
- Phoenix Link What does this mean????
- Glitching & Cutoffs with Phoenix 45
- CC35 BEC question
- CC25 Governor question - why 80%
- Zap 400 CC10 + EFlight Park 400 ... Help
- Pixie20P Cutoff voltage 6V
- Which brushed CC esc to replace burnt ICS300?
- CC25 Dead - who can fix it for me.
- CC35 & CC45
- Heat problems
- Melted CC25
- Phoenix 60 Fets
- Governor wishlist for future releases of software.
- PHX-Link via ext?
- Squeel on startup??
- lensrc 17t and ph 10 stuttering
- CC35 Glitch Problem
- CC service is as good as folks say it is!
- CC35 warming up with no xmitter input???
- please develop a.....multi motor brushless controller
- Phoenix startup chatter/stutter
- Would doing this void my warranty?
- pixie 20p help!!!
- phoenix 35 with the himax 2025 -5300kv
- Tail-wagging from governor resolved.
- phenix link and pda?
- Phx-Link Crashing
- Faulty Phoenix 10?
- Phoenix 25 - which governor mode?
- PHONIX 25- No LED
- Phoenix 10 blinking...
- Phoenix link & CC60
- Help!! Eratic start up with a CC-25
- cc10 for tail thinks left rudder is zero throttle
- CC Phoenix-10 only goes half throttle
- cc esc with parallel rx battery
- CC 45 and 6s li-po's?
- Position open in Castle Creations
- CC25 top end prob
- Where's My Phoenix 120????
- Phoenix LVC documentation problems
- New CC 25..."toneless"
- Berg Stamp 4 shrink wrap
- short cut off
- Programming
- Wishlist for documentation additions
- Phoenix 25, Himax 2025-4200 and Lipo vs NiMH???
- Phoenix 35 BEC question
- CC Pheonix 45 BEC
- CC PHX25 Problems - New Groove Dead - HELP!
- Multiple CC10's question
- Connection to PHX-Link
- Lipo cutoff and PH 25
- current limiting?
- Phoenix 10 flashing about 1 sec rate
- Himax 2015 and Phx25 Happy together? - Mixer
- Abrupt shutdown of Phoenix 25
- Where to send CC25 to get fixed??
- Pixie 20p noise?