- Link & Watt Meter Question...
- Phoenix link programming error
- Smoked my 80.......
- One cell opperation?
- When are the New High Voltage ESC coming out???
- Is Barracuda80's timing too hard for KONTORNIK motor?
- Confusion about cutoff voltage for Lipo cells.
- How to tell if CC-Phx-10 ESC is updated for use with Link?
- Mamba Power
- Outrunner Issues
- Optimal settings for CC25 and MEGA 16/7/8 motor
- Phx-60 Lost Programming
- Phoenix 10 is cutting out...
- Phoenix 25 ---- no power
- Help on CC Phoenix 35 needed
- 1.7 Beta software question
- Soft Start - On Every Speed Increase?
- Glitch Issue Found -No CC but might help diagnosis
- Phoenix 10 Set Up
- Pixie 20P compatabiltiy with 3s lipoly packs.
- phoenix 80 led flashes
- cc10 esc connection to brushless motor
- new programming
- Programming Pegasus 35P with PHX-Link
- More information on 1.08B please??
- refresh my memory. I can't use 4 servos becuase?
- 1.08b problem, go back to previous version?
- Phx-Link connection prob
- Help programming Phoenix 35 with 9C
- Need Help W/cc Programer
- c/c10 high/low
- PHx link 1.08 problems
- CC P-25!.. What is this annoying error message "An invalid argument was encountered"
- Phx-25, Park 370 Stutter
- Smoked my PHX80
- PHX-link and UBEC
- CC35 cannot be updated with PNX link
- MP-Jet & PHX-10 rough starting
- Castle Creations service = Fantastic!
- Mamba80
- Full power = servo twitching
- Engine cutting out
- Program two ESC in Parallel using Phx-Link?
- do I have to reset voltage if I want to set brake phon 10
- good repair service
- Auto Li-Po Cutoff ?
- Use Link w/motor connected?
- sorting through a crash
- Phoenix 25 and 10 link question
- Hacker B20-18L, Abrupt Start?
- CC45 on 4s Lipoly
- New PHX 25 Programming Problems
- PH-25 controller with "H" marked on it. New or old ?
- Mamba 3600 kv motor
- CC P10 and ACW DIY Outrunner
- Phx 10 run through an Sbec?
- Himax 4200 problems.
- Reverting Phoenix firmware
- CC45 at part throttle ?
- Pheonix esc problems
- How old is this Phoenix 80
- Will a phoenix 10 cut it?
- Error connecting new Phx-35 to Phx-Link
- Error connecting new Phx-35 to Phx-Link
- Himax Start-Up Solved
- Piggyback BEC for CC PH25
- Out of Sequence programming Pixie 20?
- Phx 80 fails to soft start
- Phx-35 compatible with 4S Lipoly?
- Phoenix 25 with 2 BL motors
- PHX Link Software
- Phoenix-25
- Setup Question for Phoenix 10 - Axi 2212/34 - Thunder Power 3 Cell 2100
- New CC10 low power and noisy??
- Thinking of a Hack...just gotta ask???