- Adding Ailerons
- Jamara Fournier electric sailplane
- Which Incidence Meter?
- Thick airfoils on fun fly models ?
- gurney flap
- Futaba Gyro
- Flying wings, washout and funny elevons.
- Does a neutral Thrustline go through CG?
- Flying Model Designer Position
- CG and Glide Ratio
- Fully Symetrical Airfoils?
- Flywire antenna
- Airfoil determination ?
- MotoCalc and Propeller Stalled
- Interesting VTOL idea
- aileron servo placement
- Neat online C of G calculator
- V-Tail CG shift
- Doppler Velocity & RPM Using Microphone
- washout (foam wings)
- How do I check the calibration of my DVM
- Why did the prop go slower into wind?
- How relevant are static thrust measurements?
- Windcrafter Carangifoils
- Airfoil for ducted fans and props
- Maximum lift coefficient from Polar chart.. how ?
- WINTER PROJECT - A-10 "Flying Pork"
- calculating wing area - exclude fuse?
- aileron length
- Self-Centering Prop?
- short wing chord, what am I in for?
- Autogyro Question ?
- Calling All Savants...
- Altimeter construction: C or Assembly code
- dihedral or straight?
- Dual RX battery system
- Low wing aerobatic plane dives using only rudder??
- New ailerons and CG
- Slip Rings
- Want to help with our new motor prediction software?
- Symmetrical Section for stabs?
- receiver question
- Wing Tips
- How much better is bigger?
- GWS Spitfire, twichy in flight, why the big tail?
- In-flight change from delta to wye wind (and vice-versa)?
- lift vs. altitude. what do folks in the mtns do?
- best airfoil for 24" foam Pitts?
- How far forward should the prop go?
- Sony Playstation Joystick Project
- Airfoil shape
- interested in loaded antennas
- PIC Programmer Help Needed...
- aerodynamic theory
- Tapeless construction for Zagi 400X
- Simple watt meter for the field?
- How to estimate stall speed?
- Fuselage Bending moment
- Making a Fiberglass fuse (or parts)....
- Calculations (rib, span, cg)?
- How do I figure Wing Area & Loading for "Pou Du Ciel" type Airplane???
- lap counter (please help)
- Wattage Cap 232 - tip plates?
- two vs four blades
- CG for flat, pizza box wing...
- Canards
- High-wing, mid-wing or low-wing?
- What are wings actually for?
- My design
- Prince Props?
- Bipe design Info needed
- What 'angle of incidence' should my wing be at?
- Seek information on 'Porpoising'
- What references do you recomend...
- Aerodynamic & Mass Balancing