- Drag wont matter to much at those speeds....?
- how to find the cg
- Help with thrust angle
- CG Shifts When Doubling Wt of Plane?
- Speed 400 question
- Multi-surface finishing
- Application note on the control of brushless motors
- Swept back LE = ? Dihedral
- Thrust angel of a pusher.
- Glider Vertical Stab Volume
- Homemade Y-Harness?
- Spar/longeron material comparison
- A dumb question
- ESC to Solid State Relay to Motor?
- Spinning cylinder as a wing
- What determines the revs on a Brushless motor?
- Pro Engineer 2000 Cad Software??
- How strong must a wing be?
- airspeed vs dynamic air pressure
- CG on delta wings
- how to fine refine a design?
- airfoil & planform chosen
- V-Tail .... uh ..... V-Nose Canard?
- Loss of ground effect landing on snow?
- Plantraco DSP4-SC Receiver/ESC: Yet Another Hack
- Is there such a thing as ground effect ?
- cruciform tail mixed w/ gyros -- possilbe??
- Wing loading guide needed
- Designing a 50" Pitts S-1S - Reading airfoil polars and airfoil selection
- Sweepback effects on a flying wing
- Thickening airfoil effects
- The lighter the better in weak lift ?
- Experts needed for technical puzzle question.
- Technical queston - experts needed, please
- Need help with ESC switch
- Underhanging ailerons at low Reynolds No.?
- Klingberg wing airfoil?
- Strange turning behavior
- Solder Link Help
- AG35, 36, 37 lift/drag polars wanted
- Designing FF model for SO: A few Q's
- sources of wind tunnel pics
- How does a single surface wing work?
- dihedral = lift
- Would like to find a PPP (Pull-Pull Primer)
- Converting Simulator to USB?
- Surface mount LED's
- LT-40 CG Location?
- Servo size calculation
- Flaps and Washout ?
- Foam Cutting Power Supply
- Source for 6 pin deans connector?
- airfoil simulator
- simple onboard mixer circuit
- vac bagging wings
- Aerodynamic question about Leading Edges
- Bench power supply?
- Weird .....
- trying to research phenomena
- Glue for plastic
- High Altitude Flying
- Angle of incidence
- Cubic Wing Loading
- Rebuilt Pattern Plane front end Looking for CG formula Plz help
- any good as an rc watt meter!!!!!!!!!!
- Couple of Easy Questions for the Pros
- aeronautical software
- Electronics Help Request
- Interesting Flight Sim
- Calculating CG placement
- RECEIVER with a Bec 2 channel
- Servo Reversing
- Live hinge?
- Tapered wings and stall characteristics
- Thrust measure adapter