PDA

View Full Version : Modeling Science

Pages : 1 2 3 4 5 6 7 8 9 10 [11] 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33
  1. V Tail Size
  2. Need a motor timer any ideas?
  3. Is "Rayon" Tissue Heat Shrinkable???
  4. Scaling down a plane?
  5. aileron differential
  6. Exporting from ModelCad to Autocad
  7. Simple Torque calc?
  8. Flaperons: Up or Down?
  9. Washout?
  10. Old-Timer incidence question.
  11. Tractor vs. Pusher Stability Question
  12. Design Ratios...
  13. Oswalds efficiency factor
  14. Very low Re airfoil wind tunnel data?
  15. bi-plane wing setup
  16. Propeller thrust vs. RPM
  17. aerospace engineer
  18. kitting up planes
  19. propellers,propellers and more propellers
  20. Do you need to make adjustments to CAD for lasercut kits
  21. (%mac)
  22. NACA 43012 for scale sailplane
  23. Center of Gravity for Delta wing ???
  24. How much dihedral for rudder only?
  25. Light flying wing reynold #?
  26. Community designed flying wing
  27. DIY Computer controlled xmitters
  28. Aileron/elvator or elevon/taileron?
  29. Landtastic: Landing Gear Retract Controller (and more!)
  30. OK....airfoil nerds I need your help!
  31. Wind penetration and stalled props....
  32. wing needs CG
  33. What's the purpose of Biplane "STAGGER"
  34. Tapered vs straight wing
  35. How can you cure bad airplane habits?
  36. slipping turn effect on a.o.a.
  37. How to design a wing?
  38. My first aircraft design and I've got some questions!
  39. Polyhedral and v-tail? Bad idea?
  40. wing find my cg for me
  41. electronic switch
  42. Yardstick mods for AP
  43. Living room flyer help
  44. 28x12 prop at 6000rpm, 5" from a computer...problems?
  45. Improve on the Gottingen 398?
  46. Electric Motor 101
  47. CF to CF RF Noise
  48. DIY Electronics forum poll is posted
  49. Estimating washout from Airfoil Transitions?
  50. stall characteristic
  51. Wind Tunnel/Aerodynamic Sim???
  52. Fuse station for wing CG?
  53. Which Aerofoil??
  54. Bipe Wings
  55. tethered sailplane (kite)
  56. Local Cl values for a wing during a turn...
  57. Solar powered chargers
  58. Canard Size?
  59. Home made transmitter???
  60. Light wing strut material
  61. Wing loading question when increasing scale
  62. Infrared RC project (posted on micro section too)
  63. Looking for custom foam wings
  64. slowflyer airfoil for AP
  65. Bat tail on tailless: how big?
  66. Center of lift
  67. Need help understanding building information(Arado555-3)
  68. Asymmetric designs
  69. polyhedral angle?
  70. using wing flex as control surface on a pteranodon?
  71. CG ( again )
  72. Kv ?
  73. Deans 4 pin connector wiring harness instructions
  74. Need some help, "Gear drives"
  75. A Few Questions--SAE Aero Design