- Optic 6 Owners - Need Help with DLG Launch Presets
- Tracker III Radios are here
- Multiplex Profi 4000 Mini-Tutorial / Programming How-To
- From these pics which crystal do i need?
- PCM Switch Harness "Keep Failsafe Settings"
- test data for 112 servos
- Tested JR digitals, Evo 12, & IPD it works!!!
- How to completly clear a JR 9303
- FMA M5 died what to buy
- LiPo in Tranmitter?
- Saturn 5.4g servo gears
- radio signal range
- Optic Six Flaprons almost work good.
- Airtronics VG6000, can I use other recievers?
- Synthesized Transmitter Module (FM or only PCM)
- JR 9303 + JR NER 649S PCM Receiver - Can't Get It To Work
- JR X-388s
- Eclipse 7 Battery Meltdown
- Anyone know where I can find a....
- Shadow 3 lock-ups?
- JR transmitter compatible with futaba ?
- Why is the Futaba Synth Module so hard to find?
- anybody see the new bergs
- Is it a Bad Servo?
- campac largest capacity available
- Glitching with my seeker 6?
- Which Radio
- Futaba 9C P-mix problems for the Starship Enterprise
- Futaba trainer chord for Hitech?
- JR X-2610 (XP6102) - Aileron differential?
- Radio control protocol
- JR 9303 Tx Battery Question.
- JR Crystal Issues...
- Futaba 9C AUW?
- battery cycling question
- Evo or Profi?
- Elevator compensation - profi4000
- Need some help please on selection
- In need of professional help!!
- Putting a shield between the RX & ESC?
- JR8103DT Throttle Trim
- JR 10X Question
- Problem with trim settings
- Would you buy this
- Jittering servos
- Servo conflicts
- battery checking small Rx cells
- Owning two radios W/ diff channels....disadvantage?
- What happens if two transmitter antennas touch?
- Futaba 3151's and Electron 6
- Futaba T7CHP radio reset
- How does the trainer system work?
- Eclipse 7 question for e-glider
- Major Help Please!!!!
- Charging JR 8103 battery in radio
- Does anyone modify JR to accept Futaba shift?
- Questions about radio equipment
- Digital Servo Roundup: Post your experience
- Multiplex 4000 Programming probelms - Help needed
- need help selectingradio system
- Tx with metal case (Hitec Challenger 720) Safe?
- Flaperons from 5 ch receiver
- Flash 5 V-tail programing
- Compatibility Servo Hitec with JR
- Airtronics xmtr for hlg
- Looking for some help
- Data Transfer from Futaba 9C
- Experience with Seagull or Picolario?
- Airtronics VG6DR.Good?Bad?Fair?
- I Get a Loud Buzz When I Mix TH Servos W/Airtonics
- replacing switch on futaba 6xa
- Reviews of the SPF-5 RX from Mikro Designs
- neg shift vs pos shift
- replaced GWS Pico receiver antenna with great results!!
- Where should I put the higher torque?