- I intend on using 1/4 phone jack on f5b type power, vibration no prob?
- Need 280BB Brushes?
- question about circuit diagram??
- Dual vertical tail angle?
- Good 23A Switched PSU on sale @ RS again.
- Anyone tried GP 60AAH / 100AFH NiMh yet ?
- Soldering across ends of cells
- Old Timer Prop Question??
- Receiver BEC Question
- Wattage 05 6turn cobalt help
- Should I prop for amps or efficiency?
- Mabuchi RS540SH motor question
- Mig 200 SF drive system from MEGA
- I have a gws pico servo that freaks out in the cold. Ever seen this?
- radio freq interference
- how frequent is frequency overlap
- Input Watts
- Polyhedral, Dihedral, flat...
- Storage of motors???
- What is this Reverse Differentials and how does it works?
- vertical performance poll
- Physics Project
- Fixing a warped wing
- 3M 77 Adhesive and Acetone?
- Will this propellor burn up this motor?
- Good motor / Bad motor??
- How do I tell the difference between two 400's
- OK, OK, I know this subject has been done to death.....BUT
- Which Controller for MEGA BL motors: JETI or other?
- 4mm Collet for Graupner 42mm spinner
- Full Span Ailerons
- Wing/Horiz. stab incidence
- MotoCalc vs Twin Engines
- Anyone have a discharge plot for 1100AAU cells ?
- Small magnits",Where can i buy them?"
- Good site for students
- Anybody tried breaking in a permax s400?
- Wing Incidence vs Horizontal Stab Incidence
- Pinion tooth count determines ratio? What to use to keep pinion on? Sources?
- Setting the EPA on a Flash5
- Smoke leaked out of my speed contrl but it still works - why?(?)
- Questions about Motor Timing and Lubrication
- Ace Foam wing project....power advice needed
- Kontronics Sun 1000 or FMA SW100 speed control?
- Un"strippable" servos?
- HALL Sensor and Controller
- Sky-Spy
- wing loading question
- Shock-absorbing pushrod needed. Any ideas?
- Max Amps 280BB?
- Your Thoughts on My Wild Idea
- Need help with Orbit Microlader V6.0
- 10xCP1300 at 2.6V?
- FAQ on differences between types of foam.
- Laser-cutting parts?
- Good quality external charging jack system ?
- Talk about MICRO RC!
- Learning to use AutoCAD 2002
- New Futaba trainer cords / jacks
- MotoCalc questions
- folloe up to permax s400 breakin
- Electronics kit for CNC Foam cutter--Anyone interested?
- This is the best 12V power supply for the $$$
- Micro-Balloons: How strong?
- astro 25g or 40g
- Got me a new DMM w/ PC interface, very high 'cool gizmo' factor
- Most efficient sp400 sized brushless motor and controller?
- pc power supply for fma supernova
- Ailerons versus elevons (Robbe hunter 400 exp.)
- Brushless Motors Efficiency Questions
- Rechargeable alkaline's for rc's
- Radio Help
- how to reverse rotation with a brushless motor
- Read directions, now confused on BEC
- Can rudder be mixed to compensate flapperons for adverse yaw.