- AWG wire ratings
- power supply or charger
- charging questions
- Carbon spars, antenna reception...
- Side by Side vs. End to End/stick battery packs
- Do radio antennas have a dead zone?
- How to use carbon
- Chameleon Pro data?
- Are there shifting gearboxes for your airplanes?
- V-tail Elevators?
- Brushless Motor Theory
- Need to Replace a Kyosho 240S Motor with a similar motor
- 3 servos on Jeti 050 ESC?
- Futaba Rx Question
- Can a CP8x1300SCR battery pack handle up to 40 amps?
- Propwash effects on stab location?
- A vacuum compressor question...
- Max current for MFA Rocket?
- Ecalc question
- c/10 charging with Dymond Super Turbo
- Ni-Cd Charging Formula using time vs C/10
- HELP---Want to re-inforce wing for geared Endo
- 700AAA NiMH?
- Does Motocalc exagerate gearboxes?
- I don't understand the power rating of solar cells...help
- Aveox 1015 2Y with stalled prop
- Hacker Master Controllers
- Can hot and ground be ganged leaving only signal wires singular
- 8 cell 800Mah battery charging takes too long?
- Victor Super Hi-Q
- Mega "16" series brushless? Anyone?
- how to tell the difference between futaba/hitec , and JR GWS RX's
- Props
- antenna location
- Home-made LRK-torquemax Brushless motors.
- MP Jet Gearbox Question
- RPM measurements in basement ?
- How come channel 1 seems to glitch more than any other channel.
- have Velkom VM-2014/27 - now what?
- Glue for balsa laminating a foam wing?
- Servo Ball Joints, smallest?
- Sanding Formica templates the easy way!
- How much current can I get from Radio shack 8 cell 1600 mah Nimh
- Wall wart charger question . . .
- Converting flying wing to wing/tail plane
- Max current for a Dymond MAX 480
- $1.38 AA 1600 NiMH batteries
- Overheating motors?
- Wing Area
- 1300 SCR Cells
- Cell sizes
- commercial jet liners
- Need help on cleaning up wing sheeted surface.
- AT Power Supply for 12v ????
- diversity or radical r.c.?
- What's up with Motocalc?
- Dymond Super Charger
- Pure triangular wing: what airfoil, CG?
- Makita charger/bat. packs
- Torque created by Elevons?
- FMA 20 esc & BEC
- nicad life in cold weather
- Anyone using an Aveox 4.4 to 1 box in pusher mode?
- Kirk did a bang up job on my 450 :)
- Futaba PCM receiver servo pulse other than PPM?
- Biplane wings
- RC Car Motor vs. Airplane Motors
- Calulating MAC multi part swept wing?
- New Castle Creations BL 10 amp ESC with AF 010 ?
- HR 4/5AU and HR-AU cells
- Hitec Prism 7 parallel interface
- Supernova 3000 Charger
- left handed propellers
- I ran the stock zagi through motocalc. It should be a dog. Whats wrong with motocal
- Mental anguish due to ESC-BEC system : help needed